Skip to main content
Call 24/7 Book inspection

Learning Centre · Blocked drains

Why Do My Drains Keep Blocking?

A drain that blocks once is annoying. A drain that keeps blocking is telling you something. Here are the usual reasons, how to tell them apart, and how to stop clearing the same blockage again and again.

Book an inspection Call 0401 811 972
  • Open 24 hours, 7 days
  • Price agreed before work
  • Based in Newtown
Gloved hand holding a drain camera head covered in tree roots pulled from a pipe

Guide

The short answer

Most repeat blockages come down to one of four things: what goes down the drain, what gets into the pipe from outside, a damaged pipe that catches waste, or a blockage that was cleared but never fully removed. Working out which one you have is the key to fixing it for good.

What goes down the drain

In the kitchen, fat, oil and grease are the big ones. They go down warm and runny, cool inside the pipe and set hard. Each time, a little more sticks, and food scraps and coffee grounds get caught in it. In the bathroom it is hair and soap scum, which knit together into a plug just below the plughole.

Toilets block when something goes down that does not break apart. Toilet paper is designed to fall apart in water. Wet wipes, including ones sold as flushable, sanitary products, cotton buds and paper towel are not. They snag on any rough spot in the pipe and build up.

What gets into the pipe from outside

Tree roots are one of the most common reasons a Geelong drain keeps blocking. Roots go looking for water, and a drain carries plenty of it. They find their way in through joints and small cracks, then grow into a mat that catches everything flowing past. Older properties are more likely to have pipes with lots of joints, which gives roots more places to get in.

Clearing roots opens the pipe again, but it does not seal the joint they came through. That is why root blockages often come back months later. Soil and silt can also wash in through a broken section and settle in the pipe.

When the pipe itself is the problem

Sometimes the pipe is the cause. A cracked section, a joint that has shifted out of line, or a dip where the pipe has sagged will all hold water and waste. Even normal use will build up there over time, so the drain blocks again no matter how carefully you use it.

One fixture or the whole house?

If only one sink or shower is slow, the blockage is usually close to that fixture. If several fixtures play up at the same time, the toilet gurgles when the shower drains, or water comes up through the grated gully outside, the main sewer line is involved. That needs a different approach, which we cover on our blocked sewer drains page.

Why a camera check stops the cycle

If a drain has blocked more than once, a CCTV drain inspection is usually the cheapest way to stop paying for the same job twice. A small camera goes into the pipe and shows what is causing the blockage and where it is. Then you can decide on the right fix: regular cleaning, tree root removal, a repair to one section, or pipe relining to seal the pipe from the inside.

What to do next

If your drain is blocked right now, stop using it and give us a call. We are open 24 hours, 7 days. We will clear the blockage, tell you what caused it, and agree the price with you before any work starts.

Questions

Common questions

Something else on your mind? Call us any time, day or night.

Prefer to talk it through?

Book an inspection 0401 811 972 Ask a question

Why does my drain block again after it has been cleared?

Usually because the cause is still there. Roots grow back through the same joint, or a cracked or sagging section keeps catching waste. Clearing opens the pipe, but a camera inspection shows what needs fixing so it stops happening.

How do tree roots get into a sewer pipe?

Roots are drawn to the water and nutrients in the pipe. They get in through joints and small cracks, then grow into a mat inside the pipe that catches toilet paper and waste.

Can I stop roots coming back?

Cutting roots out clears the pipe but does not seal the joint they came through, so they can return. Sealing the pipe, for example with relining or by replacing the damaged section, is what stops them getting back in.

Is a gurgling drain a sign of a blockage?

Often, yes. Gurgling means air is being pushed through water because the flow is restricted. If it happens in one fixture when another drains, the blockage is probably in the shared line further down.

Still not sure?

Ask us a question and we'll get back to you.

Ask us a question

Book an inspection

Talk to a local drain specialist

Call us any time, day or night, or book an inspection online. We agree the price with you before any work starts.

  • Open 24 hours, 7 days
  • Geelong, Bellarine and Surf Coast
  • Price agreed first
Book an inspection Call 0401 811 972
Technician seated in the back of the work van checking a CCTV drain camera monitor, with a camera reel and jetter on board

Drain problem right now? Open 24/7

Call and tell us what's happening, or book an inspection and we'll call you back. We agree the price with you before any work starts.

Call 0401 811 972 Book an inspection

One quick form

Book an inspection

Tell us where you are and what's happening. We'll call to confirm the time and price before any work.

Sewage coming up now? Call 0401 811 972. We answer 24 hours a day, 7 days.

No obligation

Ask us a question

Not sure what's going on with your drains, or which service you need? Ask away and we'll get back to you.

Something overflowing right now? Call 0401 811 972 instead.